Gateway GT5042j, Hardware Reference Manual

Page: 28 / 48

Replacing the rear fan www.gateway.com
25
Caution
Be careful not to catch the wires
connecting the power button to the
system board when rotating the fan
mount. A notch has been provided for
routing these wires.
7
Insert the tabs on the rear of the fan mount into the slots provided, then
rotate the mount into place. The mount should lock into place.
8
Reconnect the fan cable to the system board.
9
Replace the fan cover.
10
Replace the side panel by following the instructions in “Replacing the side
panel” on page 15 .
Replacing the rear fan
Tips & Tricks
You need a Phillips screwdriver to replace
the rear fan.
To replace the rear fan:
1
Remove the side panel by following the instructions in “Removing the side
panel” on page 12 .
2
Disconnect the fan cable from the system board. The location of the fan
connection may vary, so trace the fan cable from the fan to the system
board.