Gateway FX7026, Reference Manual

Page: 98 / 140

CHAPTER 6: Troubleshooting
92
Your 56K modem does not connect at 56K
Current FCC regulations restrict actual data transfer rates over
public telephone lines to 53K. Other factors, such as line noise,
telephone service provider equipment, or ISP limitations, may
lower the speed even further.
If your computer has a v.90 modem, the speed at which you
can upload (send) data is limited to 33.6K. If your computer has
a v.92 modem, the speed at which you can upload data is
limited to 48K. Your ISP may not support 48K uploads.
Your fax communications program only sends and receives
faxes at 14,400 bps when you have a 56K modem
•
Current fax technology only supports a maximum send
and receive rate of 14,400 bps.
The modem is not recognized by your computer
•
Make sure that the line connected to the modem is
working and plugged into the appropriate port on your
computer. To make sure that the connections have been
made correctly, see your setup poster or
“Connecting a
dial-up modem” on page 16 .
•
If the modem shares the telephone line with another
device, make sure that the telephone line is not in use
(for example, someone is on the telephone, or another
modem is in use).
•
Use the modem cable that came with your computer.
Some telephone cables do not meet required cable
standards and may cause problems with the modem
connection.
•
Shut down and restart your computer.
•
Run Windows modem diagnostics.
To run modem diagnostics:
1
Close all open programs.
2
Click ( Start ), then click Control Panel . The
Control Panel window opens.
3
Click Hardware and Sound , then click Phone and
Modem Options . The Phone and Modem Options
dialog box opens.
4
If the Location Information dialog box opens, enter
your location information, then click OK .
5
Click the Modems tab, click your modem, then click
Properties . The Modem Properties dialog box opens.
8512834.book Page 92 Wednesday, November 7, 2007 1:31 PM