Gateway E-842R, User Manual

Page: 136 / 164

APPENDIX B: Event Logs www.gateway.com
130
A host has accessed a
Logical Drive <
yy > for the
first time, or for the first time
following a reset or LIP. It
accessed it through Host
Loop <
xx > (ID < zz >) with
the SCSI command < check
condition, busy, or task set
full
>.
Information
[0xB2E
(2862)] First access by a
particular host after a
LIP or reset.
A host has accessed a
Logical Drive <
yy > for
the first time, or for the
first time following a
reset. ID <
zz > accessed
it through Host
Channel <
nn > with the
SCSI command
0x<
zz >.
No action necessary.
Host Loop < num > has
reported an error status of
0x<
xx > to a particular
command.
Error
[0xB37
(2871)] This may indicate a
loop reset or LIP during
a command, or a loop
failure. Repeat Count =
<
count >.
Contact Customer
Care.
Host Loop < num > has
reported an invalid status of
0x<
xx > to a particular
command.
Error
[0xB38
(2872)] This indicates a
firmware error in the
host fibre channel
chip. Contact Customer
Care.
A SAS command was
aborted on the drive w/
WWN <
xx xx xx xx xx xx xx
xx > (Slot < num >, Enclosure
< num >) for the SCSI Op
Code 0x< xx >.
Error
[0xB39
(2873)] Aborted command. Possible reasons are:
faulty disk drive, fault
drive slot, faulty
enclosure, cable issue,
faulty drive firmware,
fault in SAS expander,
excessive noise, or
possible drive
interference.
The controller has
generated a LIP on Host
Loop <
xx >, due to a loop
error.
Error
[0xB3D
(2877)] Controller initiated a
LIP. No action necessary.
The host system
w/WWN:<
xx xx xx xx xx xx >
and Loop ID of < xx > has
logged into the controller
through Host Loop <
xx >.
These events are only listed
for HBAs with SAN LUN
mappings.
Information
[0xB3F
(2879)] Host systems logs into
the controller. No action necessary.
Controller Port Event
Messages
Type [ID] Cause Action