Gateway E-4620, Reference Manual

Page: 45 / 150

www.gateway.com
39
Opening and closing the case
Your computer case provides easy access to internal
components.
To remove the side panel:
1
Follow the instructions in “Preventing static electricity
discharge” on page 38 .
2
Shut down your computer, then disconnect the power
cord and modem, network, and all peripheral device
cables.
3
Press the power button for ten seconds to drain any
residual power from your computer.
4
Lay the computer down flat, lift up the panel release
latch, then remove the panel.
5
To replace the side panel, line up the tabs on the top of
the panel with the notches near the top of the case, then
press the panel down until it snaps into place.
Warning
To avoid exposure to dangerous electrical voltages and moving parts, turn
off your computer, then unplug the power cord and modem cable before opening
the case.
Important
Some details of your computer, such as available ports, may differ from
those shown.
8512733.book Page 39 Friday, September 21, 2007 4:47 PM