66
www.gateway.com
Chapter 6: Troubleshooting
Computer
The computer will not start
■
Make sure that the power cord is connected to an AC power source and your
computer is turned on.
Diskette drive
The diskette drive is not recognized
■
Shut down and restart your computer.
You cannot save a file to diskette or you see the message “disk is full or
write-protected”
■
Make sure that the write-protection tab on the upper-right corner of the diskette
is down (unprotected).
■
Delete unnecessary files on the diskette and try again.
■
Make sure that the diskette you are using is IBM-compatible.
■
Try a different diskette. Occasionally diskettes are flawed and cannot be read by
the diskette drive.
■
Run Error-checking on the diskette. For more information, see “Checking the hard
drive for errors” in
Using Your Computer
which has been included on your hard
drive. To access this guide, click
Start
,
All Programs
, then click
Gateway
Documentation
.
If errors are detected and corrected, try using the diskette again.
You see a “Access Denied” or “Write protect” error message
■
Move the write-protection tab in the upper-right corner of the diskette down
(unprotected).
■
The diskette may be full. Delete unnecessary files on the diskette and try again.
■
Make sure that the diskette you are using is IBM-compatible.
■
Try a different diskette. Occasionally diskettes are flawed and cannot be read by
the diskette drive.
8510808.book Page 66 Thursday, June 30, 2005 7:43 AM
