CHAPTER 5: Upgrading Your Computer
50
Adding or replacing an optical
disc drive
To add replace an optical drive:
1
Remove the front bezel by following the instructions in
“Removing the front bezel” on page 47
.
2
If you are installing a new drive (not replacing an old
one), remove the two drive retention screws in the drive
bay, then go to
Step 7
. For the location of the screws, see
the photo in
Step 5
.
3
If you are replacing an existing drive, disconnect the
cables from the drive, noting their locations and
orientation. You will reconnect the cables after you
install the new drive.
4
Note any jumper settings on the old drive (if any) and set
the jumper on the new drive to be the same.
Tools
You need a Phillips screwdriver to add or replace an optical drive.
Important
The color and shape of your replacement drive’s front cover may
vary from your original drive.
Drive data cable
Drive power cable
8513217.book Page 50 Wednesday, August 27, 2008 3:30 PM
Summary of Contents for DX4710-UB301A - DX - 6 GB RAM
