Gateway ALR 9250R, User Manual

Page: 191 / 226

Appendix A: System Board Jumpers 177
12.
Move the jumper from pins 2 and 3 back to pins 1 and 2 (the Protect
CMOS memory position).
13.
Reinstall the access cover using the original screws, and connect the
power cords to the system.
14. Run BIOS Setup or the SSU to verify the correct settings. See Chapter
4,
BIOS Setup
and Chapter 5,
The Server Setup Utility
for more
information on setting BIOS and SSU fields.
Password Clear jumper
The jumper at pins 5, 6, and 7 controls whether a stored password is
retained or cleared during a system reset.
1.
See “Changing a jumper setting” on page 175.
2.
Move the Password jumper from pins 5 and 6 to pins 6 and 7.
3. Reinstall the access cover for your safety (using the original screws),
and connect the power cords to the system.
4. Turn the system on, and wait for POST to complete. This
automatically clears the password.
5.
Turn off the system, and disconnect all AC power cords.
6.
Again remove the access cover.
7. Move the jumper from pins 6 and 7 back to pins 5 and 6.
8.
Reinstall the access cover using the original screws, and connect the
power cords to the system.
9. Run the SSU to specify a new password. See “Security add-in” on
page 113 for instructions on setting a password in the SSU.
To Clear and Replace a Password Using the Jumper
9250R.book Page 177 Friday, April 9, 1999 9:44 AM