Gateway ALR 8200R, User Manual, Page: 26 / 150

16 Gateway ALR 8200R User’s Guide
Powering Up the System
Press the On/Off switch on the front panel, and the green LED on the front
panel will illuminate ON.
If you turn off the system, you must wait at least ten seconds before you
turn the system back on.
The system self-checks the memory even if the monitor is not connected. If
the monitor is connected and powered ON, the screen displays the power-up
sequence.
•
If more than one processor is installed, the system displays which
processor it is currently testing.
•
If any errors are encountered, your system displays them on the
monitor.
•
If a monitor is not connected or the system is unable to display an
error, an error beep code sounds.
•
If the system encounters an error, it is usually nonfatal, meaning
the system functions until the error can be corrected (usually
through the BIOS Setup). In the rare case of a fatal error, contact
your Technical Support for field service support.
Quick Check
If your system does not operate correctly, re-read the instructions for the
procedure(s) you have performed. If an error occurs within an application,
consult the documentation supplied with the software.
This section identifies solutions to common problems. If the suggestions in
this section are not helpful, try calling Technical Support. In the event of a
problem, the following checks should be performed:
Looking Things Over
Sometimes, the simplest things can cause trouble. If you encounter a
problem, perform the following checks:
Warning!
For safety reasons, the top
cover must be closed and
secured while the system is
running.
Note:
Under no circumstances
return any equipment
without obtaining a Return
Material Authorization
(RMA) number.
2953.book Page 16 Monday, June 15, 1998 11:27 AM