Installing Memory and Hardware 27
Installing Memory and Hardware
Installing Memory
The system board supports up to 1 GB of RAM in ECC SDRAM DIMMs.
The system board is configured with 4 DIMM banks. You can fill Bank 0,
Bank 1, Bank 2, or Bank 3 or a combination of banks with DIMMs. No
jumper settings are required for the memory size or type because this
information is automatically detected by the BIOS.
Refer to the DIMM configuration chart later in this section for valid
memory configurations. You may select any combination that provides the
total RAM required by your system and applications.
1.
Turn off the system and disconnect the power cord.
2.
Open the case, observing the static electricity precautions in
Chapter 1.
3.
Pull open the socket clamps on each side of the DIMM socket.
Figure 10: Opening the DIMM Socket Clamps
To install DIMMs
3436.book Page 27 Friday, August 7, 1998 10:23 AM
