Gateway 9510, User Manual, Page: 61 / 222

56
www.gateway.com
Chapter 4: Installing Components
10
Remove the drive rails from the old drive, then attach the rails to the new drive by
pressing the rails firmly into the side dimples on the drive.
11
Set any jumpers on the new drive. See the drive’s documentation for further
instructions.
12
Slide the new drive into the drive bay until the drive rails snap into place.
13
Connect the drive cables by following the instructions in “Routing power and data
cables to fixed drives” on page 56 . For more information, see the drive’s
documentation.
14
Follow the instructions on “Installing the bezel assembly” on page 49 .
15
Follow the instructions in “Closing the server case” on page 52 .
Routing power and data cables to fixed drives
To route power and data cables to fixed drives:
1
Follow the instructions in “Preventing static electricity discharge” on page 41 .
2
Follow the instructions in “Opening the server case” on page 42 .
3
Follow the instructions in “Removing the bezel assembly” on page 44 .
To 4-drive
bay
8510725.book Page 56 Tuesday, May 17, 2005 5:45 PM