Gateway 9510, User Manual, Page: 85 / 222

80
www.gateway.com
Chapter 4: Installing Components
6
Insert the activation key into its socket on the system board (see “System board” on
page 7 for the location of the socket.)
Push it into the socket until it is below the two retaining clips.
7
Pull the plastic tabs away from the sides of the DIMM socket. If you are replacing a
DIMM, remove the old one.
8
Holding the DIMM (or portable cache module with battery) by the edges, align the
notch on the bottom edge of the DIMM with the notch in the DIMM socket and press
it firmly into the socket. The tabs on the sides of the DIMM socket should secure the
DIMM automatically.
9
Replace the PCI expansion card in PCI slot 1 (if removed) by following the instructions
in
“Installing PCI expansion cards” on page 69 .
10
Follow the instructions in “Installing the air ducts” on page 47 .
11
Follow the instructions in “Closing the server case” on page 52 .
12
Configure the BIOS settings to enable the ROMB option.
8510725.book Page 80 Tuesday, May 17, 2005 5:45 PM