Gateway 9510, User Manual, Page: 148 / 222

143 www.gateway.com
Launching the Web Console
Check Rebuild Rate
Select the correct adapter from the
Adapter
box. Select
Rebuild Rate
from the Adapter menu.
If there is more than one adapter in the system, click each adapter and check the rebuild
rate. The rebuild rate is not affected when you clear the configuration.
Exit Web Console
Select
Exit
from the Configuration menu to quit the Web Console.
Reclaiming Hot Spare Disks
To reclaim hot spare disks during normal operation, select the drive and select
Remove
Hot Spare
from the right pane. The Web Console changes the state of the selected drives
to the READY state.
Reconfiguring Existing Arrays
This section provides instructions for adding and removing physical drives from existing
arrays.
Adding a Physical Drive to an Existing Array
To add a physical drive to an array:
1
Go to the Config View screen.
2
Highlight the logical drive and select properties from the left pane. Select the drive
to add from the
Add Physical Drive
pane.
Removing a Physical Drive from an Array
To selectively remove hard drives from an existing array:
1
Go to the Config View screen.
2
Highlight the logical drive you want to remove, then select
Delete
from the left pane.
8510725.book Page 143 Tuesday, May 17, 2005 5:45 PM