Gateway 9415, User Manual

Page: 150 / 188

145 www.gateway.com
Electronic specifications
Memory map
Interrupts
The following table reflects a typical configuration, but you can change these interrupts.
Use this information to determine how to program each interrupt. The actual interrupt
map is defined using configuration registers in the ICH5-R (I/O controller). I/O Redirection
Registers in the I/O APIC are provided for each interrupt signal. The signals define hardware
interrupt signal characteristics for APIC messages sent to local APIC(s).
Address Range (hex) Amount Function
0 to 07FFFFh 640 KB DOS region, base system memory
0A0000h to 0BFFFFh 128 KB Video or SMM memory
0C0000h and 0DFFFFh 128 KB Expansion card BIOS and buffer area
0E0000h to 0FFFFFh 128 KB System BIOS
0E0000h to 0EFFFFh 2 MB Extended system BIOS
FC000000h to FFFFFFFFh 64 MB PCI memory space
Important If you disable an IDE controller to free the interrupt for that controller,
you must physically unplug the IDE cable from the system board.
Simply disabling the drive by configuring the BIOS option does not
make the interrupt available.
ISA Interrupt Description
IRQ0 Timer/counter, HPET #0 in legacy
replacement Mode. In APIC mode,
cascade from 8259 controller 1
IRQ1 Keyboard controller
IRQ2 Slave controller INTR output. In APIC
mode Timer/counter, HPET #0
IRQ3 Serial port A
IRQ4 Serial port B
IRQ5 Parallel port (not implemented)
8510522.book Page 145 Wednesday, March 16, 2005 11:19 AM