Gateway 930 series, System Manual

Page: 94 / 160

86
Using the BIOS Setup Utility
4
Place a jumper on pins 5-6 of J9. (See “System board” on page 8 for the
jumper location).
5
Reinstall the side cover panel. (See “Replacing the side panel” on
page 27.)
6
Reconnect external devices, the power cord(s), and the modem cable (if
installed).
7
Place the bootable diskette containing the BIOS files into drive A:, then
turn on the server.
At the start of the BIOS recovery process, the computer beeps once and
the floppy drive LED will go on. The recovery process may take a few
minutes.
8
When you hear three short beeps, then one continuous beep, remove the
diskette from drive A: and turn off the server.
9
Remove the side panel. (See “Removing the side cover panel” on page 26.)
10
Remove the jumper from pins 5-6 of J9.
11
Reinstall the cover panel. (See “Replacing the side panel” on page 27.)
12
Reconnect external devices, the power cord(s), and the modem cable (if
installed).
13
Enter the BIOS Setup utility by pressing F1 when the Gateway Logo screen
appears.
14
Once in the BIOS Setup utility, go to the appropriate menu and select
any BIOS fields you want to change, then reenter the values you wrote
down at the beginning of this process.
15
Save your changes, then exit the BIOS Setup utility.
Troubleshooting: If the BIOS recovery was unsuccessful, go back to the
Gateway Web site and start the process over. If you continue to have problems,
contact Gateway Technical Support.
8508088.book Page 86 Thursday, November 1, 2001 9:35 AM