Gasmate Keystone GM142-140, Manual

Page: 7 / 12

7 6
ASSEMBLY INSTRUCTIONS
STEP 5b
Tighten the connections using a crescent then
repeat steps 3-4.
STEP 5b
The connection is gas tight when no bubbles grow
around the gas connection.
STEP 7
Place all lava rocks evenly in the fire table on the
top of the appliance. Never cover the ignition
screen when placing the lava rocks into the fire
table. Always keep ignition screen visible.
Note: images are examples only.
Burner shape may differ from the images below.
WARNING: This screen must be clear and
free of obstructions at all times to ensure
proper operation.
STEP 11
Ensure cylinder valve is in its full off position. Check
for any damage to either the cylinder connection or
the hose. NEVER attempt to use damaged equipment.
Attach the regulator and hose to your gas cylinder.
Tighten the nut to a positive stop by hand.
STEP 12
Turn on the gas cylinder ensuring that the control knob
on the outdoor heater is turned OFF at this point.
DO NOT ATTEMPT TO LIGHT THE HEATER!!.
STEP 13
Use a solution of soapy water (dishwashing liquid and
water is fine). Brush it on or use a spray bottle as
shown in the drawing. Ensure the connections have a
good coating.
STEP 14a
If the connection is leaking, bubbles will start to grow
in the soapy solution. If this happens shut off the gas
supply at the cylinder.
STEP 14b
Tighten the connections using a crescent then repeat
steps 12-13.
STEP 14c
The connection is gas tight when no bubbles grow
around the gas connection.
ASSEMBLY INSTRUCTIONS
STEP 11
Ensure cylinder valve is in its full off position. Check
for any damage to either the cylinder connection or
the hose. NEVER attempt to use damaged equipment.
Attach the regulator and hose to your gas cylinder.
Tighten the nut to a positive stop by hand.
STEP 12
Turn on the gas cylinder ensuring that the control knob
on the outdoor heater is turned OFF at this point.
DO NOT ATTEMPT TO LIGHT THE HEATER!!.
STEP 13
Use a solution of soapy water (dishwashing liquid and
water is fine). Brush it on or use a spray bottle as
shown in the drawing. Ensure the connections have a
good coating.
STEP 14a
If the connection is leaking, bubbles will start to grow
in the soapy solution. If this happens shut off the gas
supply at the cylinder.
STEP 14b
Tighten the connections using a crescent then repeat
steps 12-13.
STEP 14c
The connection is gas tight when no bubbles grow
around the gas connection.
ASSEMBLY INSTRUCTIONS
Correct Incorrect
Screen
DO NOT
place Lava
rocks on the
screen. Keep
screen clear.
STEP 6
The ignition system works by battery. Unscrew
the electronic igniter button and insert the AAA
battery included. Make sure the positive pole (+) is
towards the outside. Re-screw the button back to
the battery case tightly.