6
STEP 2
This is a 2 person assembly.
A. To assemble the glass surround panels position the 4pcs of bottom aluminium brackets on the top of the fire pit,
ensuring that the pin goes into the small hole. Screws should be facing the inside.
Make sure you have the top brackets close by before you start assembling the glass in step B and step C.
B. Take 1pc of glass panel and slide into 2 of the bottom brackets and lightly tighten the screws against the glass.
C. Take another glass panel and slide this into the next 2 bottom brackets, again lightly tighten the screws against the
glass. Now take a top bracket and install this between the 2 glass panels, level with the top of the glass and lightly
tighten the screws against the glass. Repeat this step C until all 4pcs of glass panel are assembled and secured
with the 4pcs bottom bracket and the 4pcs top bracket.
D. Once all 4pcs in position, tighten the screws so that the glass does not fall out.
STEP 3
A. Pull open the door and lift away.
B. Position the 9kg propane cylinder into the ring at the bottom.
C. Connect the regulator to the propane gas cylinder.
D. Ensure that this connection is done properly and then leak test as per page 4 before using.
Screw
Screw
Screw
Screw
Bottom joined
with base