3
Installation, Operation and Maintenance Instructions
7. The hose must be protected from contact with
hot or sharp surfaces both during use and while
in storage. The hose assembly should be visually
inspected prior to each use of the heater. If
excessive abrasion or wear is evident, or the hose
is cut, it must be replaced prior to operating the
heater. The replacement hose assembly may be
obtained from the manufacturer.
8.
DO NOT use any pressure regulator or hose
assembly other than those supplied with the
appliance. Replacement pressure regulator
and hose assembly must be those specified.
Replacement parts may be obtained from the
manufacturer or your local sales representative.
9. Installation and use of this appliance must conform
with local codes and AS/NZS 5601.
10. This appliance is designed to operate with a
standard 9Kg propane cylinder with Approved
Cylinder Connection.
11. The valve outlet must be maintained in good
condition. When the cylinder is not in use, be sure
to cover it with a dust cap. A leak test should be
performed with soapy water whenever connecting a
new cylinder.
NEVER use a match to test for leaks.
12. The propane cylinder must be turned off whenever
the appliance is not in use. When the appliance
is to be stored indoors, the propane cylinder and
the heater must be disconnected and the cylinder
stored in accordance with the Standard for Storage
and Handling of Liquefied Gases.
IMPORTANT
Storage of an appliance indoors with the cylinder
attached is only permitted if the size of the cylinder
complies with AS/NZS 1596; otherwise cylinders
must be stored outdoors in a well ventilated area.
The guards are fitted to this appliance to reduce
the risk of fire or injury from burns and no part of it
should be removed.
This appliance must be protected from exposure to
rain. Use cover, not supplied.
This appliance must not be operated in the rain.
Any modification to the appliance not described in the
installation instructions may compromise the safety of
this appliance. Special concern is as follows:
(1)
DO NOT bypass thermocouple;
(2)
DO NOT operate the appliance without
the glass guard;
Clothing or other flammable materials should not be
hung from the heater, or placed on or near the heater.
The area above the burner may be extremely hot. Direct
contact with these metal surfaces should be avoided in
order to prevent burns or clothing ignition.
Screw the coupling nut of regulator into the cylinder valve
outlet.
POL CYLINDER CONNECTION DEVICE
Type of Gas
Propane
Consumption
32 MJ/h
Operating Pressure
2.75 kPa
Injector Size
1.58 mm
Appliance specifications can be found on the data label.