2
Installation, Operation and Maintenance Instructions
INSTALLATION
3. Proper clearance from combustible materials must
be maintained at all times. The minimum clearances
are as follows:
Minimum Clearance from Combustibles:
Side
500 mm
Rear
500 mm
Ceiling
1000 mm
Combustible materials are considered to be wood,
compressed paper, plant fibres, plastic, plexiglas or
other materials capable of being ignited and burned.
Such materials shall be considered combustible even
though flame proofed, fire-retardant treated or plastered.
Additional clearance may be required for glass, painted
surfaces and other materials which may be damaged by
radiant or convection heat.
4. The appliance must be placed on a level and
adequate footing and be readily accessible.
5. The gas manifold supply pressure must be regulated
at 2.75 kPa utilising an AGA approved regulator
(supplied with heater).
6. The appliance must be inspected before each use,
and at least annually by a qualified service person.
a. The appliance area must be kept clear and free
of combustible materials, gasoline and other
flammable vapours and liquids.
b. Gas orifices and burner must be kept clear of
dirt and cobwebs. Flow of combustion and
ventilation air through the perforated portions
of the heater must not be obstructed. Cleaning
with a soft brush before use and at least every
six months is recommended.
c. All gas connections should be checked for
leaks utilising a soap solution. Never use a
flame for this purpose.
d. The flame pattern should be visually checked
whenever the appliance is operated. If flames
extend beyond surface of the guard the
appliance should be turned off and should not
be operated again until the unit is serviced and
or repaired.
e. Any cleaning agent used on the appliance
should be of a non-combustible and non-
corrosive nature.
Important Safety Rules
This appliance must only be used in a well
ventilated area.
1. This appliance shall not be installed or used
indoors, in buildings, garages or any other
enclosed area.
2.
DO NOT place articles on or against this
appliance.
3.
DO NOT use or store flammable materials near
this appliance.
4. Children and adults should be alerted to the
hazards of high surface temperatures, burns
and clothing ignition.
5. Children should be carefully supervised when
they are in the area of the appliance.
6.
NEVER hang anything including clothes or
other flammable items on the appliance.
7.
DO NOT operate this appliance unless it is
fully assembled with burner guard in place.
8.
DO NOT SPRAY AEROSOLS IN THE
VICINITY OF THIS APPLIANCE WHILE IT IS
IN OPERATION.
9. Installation and repair should be done by a
qualified service person. The appliance must
be inspected before use and at least annually
by a qualified service person. It is imperative
that the control compartment, burners and
circulating air passages of the appliance be
kept clean.
Prior to assembling your appliance, the following must
be reviewed. Compliance with the following should result
in satisfactory heater operation. This instruction manual
should be retained for future reference. The installation
must conform with local codes or authority having
jurisdiction.
1. The appliance is intended for residential and non-
residential outdoor spaces. The installation must
conform with local codes and with the Australian
Standard AS/NZS 5601.
2. Adequate clearance around air openings into the
combustion chamber, clearances from combustible
materials, provisions for accessibility and for
combustion and ventilating air supply must be
maintained at all times when the appliance is
operating.