PIC. 1
GENERAL ASSEMBLY
CONNECTING & DISCONNECTING
TO GAS SOURCE
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
Note: Remove any transit protection material.
ASSEMBLY & CONNECTION
Review the contents of the package. Make sure all
listed components are included.
1. Check that the Burner Caps, Drip Tray & Trivet are in
correct locations (Pic. 1).
2. Attach the LP Gas hose to the cooker using a
spanner – Do Not Over Tighten (Pic. 2).
3. Check that the cylinder is filled, a sloshing sound will
be heard when shaken.
4. Connect the Regulator to the cylinder valve and
tighten (Pic. 3).
5. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to
use damaged equipment.
6. Turn the gas cylinder valve on and spray gas leak
detection spray or soapy water on all connections to
check for leaks. If a leak is detected turn the valve
off, retighten all connections and retest.
LIGHTING THE COOKER
1. Turn the gas cylinder valve on, in an anti-clockwise
direction for one full turn (Pic. 4).
2. Turn the Gas Control in the Anti-Clockwise Direction
till you hear the Piezo “click” and a Ignition Flame
will ignite the Burner (Pic. 5).
3. If the burner does not ignite, turn the gas control
in the clockwise direction to the “OFF” position and
allow the residual gas to disperse before attempting
to reignite the burner (Pic. 6).
6
• Do not smoke when attempting to ignite appliance.
• Always use protective gloves when handling
hot components.
• Do not smoke at any time when attempting to
ignite the appliance burners.
Caution: Do not move the appliance while in operation.
• Do not leave the appliance unattended when alight.
Before connecting and disconnecting appliance to
gas source, make sure burner controls are in ‘OFF’
position.
IMPORTANT
PIC. 2
PIC. 3
PIC. 4
