TUNING THE CHASSIS 10
41
10.16
Handlebar position
C00248-10
On the upper triple clamp, there are 2 holes at a distance of
A
to each
other.
Hole distance A
15 mm (0.59 in)
The holes on the handlebar supports are placed at a distance of
B
from the center.
Hole distance B
3.5 mm (0.138 in)
The handlebar supports can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable position
for the rider.
10.17
Adjusting the handlebar position
Warning
Danger of accidents
A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
C00249-10
–
Remove screws
1
. Take off the handlebar clamps. Remove the
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
2
. Take off the handlebar support.
–
Place the handlebar support in the required position. Mount and
tighten screws
2
.
Guideline
Screw, handlebar
support
M10
40 Nm (29.5 lbf ft)
Loctite
®
243™
–
Position handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position handlebar clamps. Mount screws
1
and tighten evenly.
Guideline
Screw, handlebar
clamp
M8
20 Nm (14.8 lbf ft)
Info
Make sure the gap widths are even.
