GAS GAS EC 350F, Owner'S Manual

Page: 67 / 150

SERVICE WORK ON THE CHASSIS 12
65
F03207-11
–
Position the main silencer. Mount screws
1
with the washers, but
do not tighten yet.
–
Attach spring
2
.
Spring hook (50305017000C1)
–
Tighten screws
1
.
Guideline
Remaining screws,
chassis M6 10 Nm (7.4 lbf ft)
12.28 Changing the glass fiber yarn filling in the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn filling escape and the damper "burns" out.
Not only is the noise level higher, but the performance characteristics change.
Preparatory work
–
Remove main silencer. ( p. 64)
V01734-10
Main work
–
Remove screws
1
.
–
Take off silencer cap
2
with O-ring
3
.
–
Remove the old glass fiber yarn filling.
–
Clean the parts that need to be reinstalled and check for damage.
–
Fit new glass fiber yarn filling
4
into the main silencer.
–
Mount the O-ring on the silencer cap.
–
Position the silencer cap.
–
Mount and tighten all of the screws.
Guideline
Screws on main
silencer M5 7 Nm (5.2 lbf ft)
Finishing work
–
Install the main silencer. ( p. 64)