Please note that alarm time setting seize to function when the clock is in RCC
synchronization mode. Wait until synchronization has ended before setting the alarm
time.
Configuring the Thermometer
This weather station is equipped to synchronize up to 3 remote temperature sensors.
One remote temperature sensor is included. Additional remote temperature sensor is
available for purchase separately. Please contact your local distributor for purchase.
Remote temperature sensors
Fig. 4 Back View
Fig. 5 Back view - open
RTS 1.
Hang hole
RTS 2.
Battery compartment screws
RTS 3.
“TX” button
RTS 4.
“RESET” button
RTS 5.
“Channel 1 2 3” switch
Batteries installation
1. Open battery compartment on the back of the unit by removing the
two small screws (RTS 2) with a Philips head screwdriver. (see figure
4)
2. Install / replace with 2x “AAA” size batteries in the compartment. It is
recommended that only alkaline batteries are used. Do not use
rechargeable batteries.
3. The weather station is capable of receiving up to 3 different channels.
Select the channel number (1, 2, or 3) by sliding the “Channel 1 2 3”
switch (RTS 5). If you only have 1 remote temperature sensor, select
1.
4. Press the “reset” button (RTS 4) once and the red light will flash once.
5. Replace the battery compartment on the back of the unit by tightening
the two screws (RTS 2).
Installation
1. Place the remote temperature sensor at a desired place by mounting
the unit’s hang hole (RTS 1) on a screw (screw not included).
