Changing the Bands
The watch is compatible with standard quick-release bands. Venu 3S has 18 mm wide bands, and Venu 3 has
22 mm wide bands.
1 Slide the quick-release pin on the spring bar to remove the band.
2 Insert one side of the spring bar for the new band into the watch.
3 Slide the quick-release pin, and align the spring bar with the opposite side of the watch.
4 Repeat steps 1 through 3 to change the other band.
Viewing Device Information
You can view the unit ID, software version, regulatory information, and license agreement.
1 Hold .
2 Select Settings > System > About.
Viewing E-label Regulatory and Compliance Information
The label for this device is provided electronically. The e-label may provide regulatory information, such as
identification numbers provided by the FCC or regional compliance markings, as well as applicable product and
licensing information.
Hold for 10 seconds.
Device Care
NOTICE
Avoid extreme shock and harsh treatment, because it can degrade the life of the product.
Avoid pressing the buttons under water.
Do not use a sharp object to clean the device.
Never use a hard or sharp object to operate the touchscreen, or damage may result.
Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and finishes.
Thoroughly rinse the device with fresh water after exposure to chlorine, salt water, sunscreen, cosmetics,
alcohol, or other harsh chemicals. Prolonged exposure to these substances can damage the case.
Keep the leather band clean and dry. Avoid swimming or showering with the leather band. Exposure to water or
sweat can damage or discolor the leather band. Use silicone bands as an alternative.
Do not store the device where prolonged exposure to extreme temperatures can occur, because it can cause
permanent damage.
Device Information
71
