20
Garmin DriveSmart™ 50LM
Garmin DriveSmart™ 50LM
21
①
Power key
②
Mini-USB power and data port
③
Map and data memory card slot
④
Microphone for Voice Command or
hands-free calling
Connecting the Device to Vehicle
Power
WARNING
This product contains a lithium-ion battery. To
prevent the possibility of personal injury or
product damage caused by battery exposure
to extreme heat, store the device out of direct
sunlight.
Before you use your device on battery power,
you should charge it.
1
Plug the vehicle power cable
①
into the
USB port on the device.
2
Press the mount
②
onto the suction cup
③
until it snaps into place.
3
Press the suction cup to the windshield,
and flip the lever
④
back toward the
windshield.
4
Fit the tab on the top of the mount into
the slot on the back of the device.
5
Press the bottom of the mount into the
device until it clicks.
6
Plug the other end of the vehicle power
cable into a power outlet in your vehicle.
Turning the Device On or Off
• To turn the device on, press the power key,
or connect the device to power.
• To put the device in power saving mode,
press the power key while the device is on.
While in power saving mode, the screen is
off and the device uses very little power,
but it can wake instantly for use.
TIP:
You can charge your device faster by
putting it in power saving mode while
charging the battery.
• To turn off the device completely, hold the
power key until a prompt appears on the
screen, and select
Off
.
The prompt appears after five seconds.
If you release the power key before the
prompt appears, the device enters power
saving mode.
Acquiring GPS Signals
When you turn on your navigation device,
