background image

Garmin GTX 330 Series Supplement                                                                                                               GRT Avionics

Revision A                                                                                                                                                          GTX 330-7

Section 4: Pilot’s Guide

4.1  Using the GTX 330

Standard operating procedures apply to GTX 330 transponders when used with GRT EFIS systems.
Please refer to the Garmin GTX 330 user manual for transponder operating instructions.

4.2  Traffic Display Icon

When the display unit is programmed to the specifications in Section 3, traffic alerts will pop up

on  the  map  and/or  primary  flight  display  automatically  when  within  range  of  radar-based  TIS
(Traffic Information Service) or ADS-B when equipped with an ADS-B receiver.

ADS-B and TIS traffic alerts use the same symbols. Note that if target aircraft do not have Mode C

capability, altitude information is omitted from the icon.

In  the  example  given  here,  your  aircraft  is  the  large  icon  in  the
center of the circle. The target traffic is at your 1 o’clock position,
700 feet above you, climbing at least 500 fpm, and  heading nearly
the same direction.

+07

Lateral Vector

Ground track of

target (direction is

away from Target

Vertical Vector

Up Arrow=Climbing

Down Arrow=Descending

No Arrow=Change in

altitude of <500 fpm

Target Icon

Last known position of

target. Appears as a

solid circle on PFD.

Altitude

Relative altitude of target

in hundreds of feet.

+ = Above you

- = Below you

Summary of Contents for GTX 330









Reviews: