6-9
190-01004-03 Rev. P
GTN 625/635/650 Pilot’s Guide
Proc
6.4
Selecting an Approach
Only one approach can be loaded at a time in a flight plan. If an approach
is loaded when another approach is already in the active flight plan, the new
approach replaces the previous approach. The route is defined by selection of an
approach, the transition waypoint, and a runway.
NOTE:
In software v6.21 and later, the pilot may load an alternate
approach during a missed approach procedure. The GTN retains all
missed approaches in the flight plan.
1. Touch the
PROC
key on the Home page. The Approach, Arrival,
and Departure fields will be dashed until a selection is made.
Touch to Select
Departure
Arrival
Touch to Select
Approach
Figure 6-15 Procedures Selection Window
2. Touch the
Approach
key on the Procedures page to select
an approach for the destination airport. Confirm that the
intended airport is shown or touch the
Airport
the desired airport.
NOTE:
If using Descent VNAV, verify that the altitudes for the selected
procedure match the charted or ATC cleared altitudes and are appropriate
for the airframe type.
Touch to Select
Approach
Touch to Select
Airport
Touch to Select
Channel ID
Figure 6-16 Selecting an Approach
Summary of Contents for GTN 625
Page 608: ...This page intentionally left blank ...
Page 609: ......
Page 610: ...190 01004 03 Rev P ...