Transom-Mount Transducer
Installation Instructions
To obtain the best performance and to avoid damage to your
boat, you must install the Garmin
®
transducer according to these
instructions.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation,
contact Garmin Product Support.
Registering Your Device
Help us better support you by completing our online registration
today.
• Go to
• Keep the original sales receipt, or a photocopy, in a safe
place.
Contacting Garmin Product Support
• Go to
and click
Contact Support
for in-country support information.
• In the USA, call (913) 397.8200 or (800) 800.1020.
• In the UK, call 0808 2380000.
• In Europe, call +44 (0) 870.8501241.
Important Safety Information
WARNING
See the
Important Safety and Product Information
guide in the
product box for product warnings and other important
information.
You are responsible for the safe and prudent operation of your
vessel. Sonar is a tool that enhances your awareness of the
water beneath your boat. It does not relieve you of the
responsibility of observing the water around your boat as you
navigate.
CAUTION
Failure to install and maintain this equipment in accordance with
these instructions could result in damage or injury.
Always wear safety goggles, ear protection, and a dust mask
when drilling, cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite
side of the surface.
Loading the New Software on a Memory
Card
You must copy the software update to a memory card.
1
Insert a memory card into the card slot on the computer.
2
Go to
www.garmin.com/support/software/marine.html
.
3
Select
Download
next to “Garmin Marine Network with SD
card”.
4
Read and agree to the terms.
5
Select
Download
.
6
If necessary, select
Run
or save and open the file.
7
If necessary, select the drive associated with the memory
card, and select
Next
>
Finish
.
Updating the Device Software
Before you can update the software, you must obtain a
software-update memory card or load the latest software onto a
memory card.
1
Turn on the chartplotter.
2
After the home screen appears, insert the memory card into
the card slot.
NOTE:
In order for the software update instructions to
appear, the device must be fully booted before the card is
inserted.
3
Follow the on-screen instructions.
4
Wait several minutes while the software update process
completes.
The device returns to normal operation after the software
update process is complete.
5
Remove the memory card.
NOTE:
If the memory card is removed before the device
restarts fully, the software update is not complete.
Tools Needed
• Drill and drill bits
• 7 mm wrench
• 3 mm hex wrench
• Number 2 Phillips screwdriver
• Masking tape
• Marine sealant
About the Transducer
The transducer transmits and receives sound waves through the
water, and relays sound-wave information to your Garmin sonar
device.
Assembling the Transducer
1
Secure the mount
À
to the transducer
Á
with the included
8 mm M4 screws
Â
, 4 mm flat washers
Ã
, and M4 split
washers
Ä
.
2
Secure the mount to the bracket
Å
with the included 12 mm
M4 screws
Æ
, M4 flat washers
Ç
, and M4 lock nuts
È
.
NOTE:
You can use the 7 mm wrench to hold the lock nut in
place while you tighten each 12 mm M4 screw.
October 2014
Printed in Taiwan
190-01681-02_0B
