Garmin GPSMAP 9000 Series, Owner'S Manual

Page: 201 / 232

Other Vessels Settings
CAUTION
The Beeper setting must be turned on to make alarms audible ( Sounds and Display Settings, page 175 ). Failure
to set audible alarms could lead to injury or property damage.
When your compatible chartplotter is connected to an AIS device or VHF radio, you can set up how other
vessels are displayed on the chartplotter.
Select Settings > Other Vessels.
AIS: Enables and disables AIS signal reception.
DSC: Enables and disables digital selective calling (DSC).
Collision Alarm: Sets the collision alarm (
Setting the Safe-Zone Collision Alarm, page 41 ).
AIS-EPIRB Test: Enables test signals from Emergency Position Indicating Radio Beacons (EPRIB).
AIS-MOB Test: Enables test signals from man overboard (MOB) devices.
AIS-SART Test: Enables test transmissions from Search and Rescue Transponders (SART).
Settings that are Synced on the Garmin Marine Network
Garmin ECHOMAP
™
and GPSMAP chartplotters sync certain settings when connected to the Garmin Marine
Network.
The following settings are synced, if applicable, to the device.
Alarm Settings (also syncs alarm acknowledgment):
• Arrival
• Anchor Drag
• Off Course
• GPS Accuracy
• Shallow Water
• Deep Water (Not available in the GPSMAP 8400/8600 series)
• Water Temp.
• Contour (Not available in echoMAP 70s and GPSMAP 507/701 series)
• Fish
• Collision Alarm
General Settings:
• Auto Guidance Preferred Depth
• Auto Guidance Vertical Clearance
• Beeper
• Color Mode
• Keyboard Layout
• Language
• Map Datum
• Heading
• Position Format
• System Units
• Calibrate Water Speed
• Radar Antenna Size
Chart Settings:
• Chart Borders
• Hazard Colors
• Heading Line
Device Configuration 187