GPSMAP 700 Series Owner’s Manual
75
Sonar
Showing Surface Noise
You can set whether the sonar returns near the surface of the water appear. Hide surface noise to help reduce
clutter.
From the Home screen, select
Sonar
>
Sonar Setup
>
Surface Noise
>
Show
.
Showing and Configuring a Depth Line
You can set whether a quick-reference depth line appears.
1. From the Home screen, select
Sonar
>
Sonar Setup
>
Depth Line
>
Show
.
2. Touch and drag the reference line to set the depth of the line.
Showing the A-Scope
The A-Scope is a vertical flasher along the right side of the screen that shows instantaneously the range to
targets along a scale.
From the Home screen, select
Sonar
>
Sonar Setup
>
A-Scope
>
on
.
Setting Pic Advance
The picture advance setting allows the sonar picture to advance faster by drawing more than one column of
data on the screen for each column of sounder data received. This is especially helpful when you are using
the sounder in deep water, because the sonar signal takes longer to travel to the water bottom and back to the
transducer.
The
1/1
setting draws one column of information on the screen per sounder return. The
2/1
setting draws two
columns of information on the screen per sounder return, and so on for the
4/1
and
8/1
settings.
1. From the Home screen, select
Sonar
>
Sonar Setup
>
Pic. Advance
.
2. Select a picture advance setting.
Showing Overlay Numbers
You must have a water-speed sensor or a speed-capable transducer to show water-speed information, and
you must have a water-temperature sensor or a temperature-capable transducer to show water-temperature
information.
You can set water temperature, unit voltage, water speed (if your transducer is capable), and navigation
information to appear automatically on the Sonar screens. The navigation information always includes GPS
speed and GPS heading, and includes bearing and off-course information while navigating.
1. From the Home screen, select
Sonar
>
Sonar Setup
>
overlay Numbers
.
2. Complete an action:
• Select
Depth
>
Show
.
• Select
Water Temp
>
Auto
.
• Select
Water Speed
>
Auto
.
• Select
Unit Voltage
>
Show
.
• Select
Navigation
>
Auto
.
If you select
Auto
, and if the information is available, the data appears on the Sonar screen.
Configuring the Appearance of Suspended Targets
You can set how the sonar interprets suspended targets.
1. From the Home screen, select
Sonar
>
Sonar Setup
>
Appearance
>
Fish Symbols
.
2. Complete an action:
• Select
to show suspended targets as symbols with background sonar information.
• Select
to show suspended targets as symbols with background sonar information and target depth
information.
• Select
to show suspended targets as symbols.
• Select
to show suspended targets as symbols with target depth information.
