Garmin GPSMAP 3006C, Owner'S Manual

Page: 15 / 116

GPSMAP 3006C/3010C Owner’s Manual 7
G
ETTING
S
TARTED
> I
NITIALIZING THE
GPS R
ECEIVER
Receiver Status and Accuracy
The receiver status is shown in the Status field on the Info sub tab. Current
accuracy is shown in the EPE (Estimated Position Error) field. Accuracy uses the
number of received GPS satellites, signal strength, and satellite orientation, to
calculate location accuracy in feet or meters. The Status field shows one of the
following conditions:
• Searching for Satellites —the receiver is looking for any satellites and
collecting data from satellites visible at its last known or initialized
location, but has not collected enough data to calculate a fix. This process
can take up to five minutes.
• Ready For Navigation —at least three satellites with good geometry have
been acquired, and your location is now being calculated in latitude and
longitude; or at least four satellites have been acquired and your location
is being calculated in latitude, longitude, and elevation. “Ready For
Navigation with WAAS” appears when you are receiving WAAS satellite
corrections in 2D or 3D, and a D appears on the strength bar of satellites
being corrected.
After the receiver has collected information from at least three satellites, the
Status field shows either “Ready for Navigation” or “Ready for Navigation with
WAAS.” The GPSMAP 3006C/3010C is now ready for use. Press
QUIT
to return
to the Map Page.
GPS Setup
The Setup sub tab provides access to functions and features relating to initializing
the GPS receiver.
To access the GPS Setup sub tab:
1. Press and hold ADJ/MENU to open the Main Menu.
2. Highlight the
GPS
tab, and then highlight the
Setup
sub tab.
Setup Sub Tab
The GPS Setup Tab contains the following options:
Skyview Orientation —allows you to select a sky view orientation, either North
Up or Track Up, for the GPS Info sub tab only.
Source
—set to
Garmin
when using a Garmin sensor (GPS 17); set to
NMEA
when using any other GPS NMEA source.
WAAS —turns WAAS on or off.
The following soft keys are active only when the unit is not receiving satellites
and the Source is not set to Garmin :
•
AutoLocate
—allows the receiver to find your location automatically. This
process can take up to five minutes.
•
Set Position
—allows you to initialize the receiver from the Map Page to
initially help the receiver acquire satellites more quickly.