Garmin GPSMAP 3006C, Owner'S Manual

Page: 107 / 116

GPSMAP 3006C/3010C Owner’s Manual 99
A
PPENDIX
> M
ESSAGES AND
A
LARMS
Not All Maps Fit, Some Maps will not be drawn —the maximum number of
individual maps on the data card was exceeded.
Off Course Alarm —you exceeded the specified off-course distance.
Proximity Alarm Memory is Full —you used all available proximity waypoints.
Proximity Alarm: <Waypoint>
—you entered the alarm radius for the proximity
waypoint indicated.
Proximity Overlaps Another Proximity Waypoint
—the alarm radius specified
overlaps the area specified for another proximity waypoint. Adjust the distance.
Route Already Exists: <route name>
—you entered a route name that already
exists in memory. Modify the route name or delete the previous route name.
Route Is Full —you attempted to add more than 300 points to a route. Reduce the
number of points or create a second route.
Route Memory Is Full, Can’t Create Route —the maximum amount of 300
routes is already in the unit’s memory, and no additional routes can be added until
existing ones are removed.
Route Truncated —an uploaded route from another device has more than 300
points and was truncated to fit.
Route Waypoint Memory Full —no additional route waypoints can be saved.
Shallow Water Alarm —the Shallow Water Alarm depth has been reached.
Simulating Operation
—the unit is in Simulator Mode. Do not use this mode for
normal navigation!
Sonar Failed, Unit Needs Repair
—there is an internal problem with the unit.
Contact your dealer or Garmin Product Support to have the unit serviced.
Sonar Service Incompatible
—the external sonar device you are connected to
needs a software update.
Sonar Service Lost —the external sonar device you were connected to has either
been disconnected, or the GPSMAP 3006C/3010C has lost communication with
the sonar device for some other reason.
Timer Alarm
—the Timer has reached to 00:00:00.
Track Already Exists: <track name> —you entered a saved track name that
already exists in memory. Modify the track name or delete the existing track.
Track Memory Is Full, Can’t Create Track —the track log memory is full. No
additional track log data can be stored without deleting old data.
Track Truncated —a complete uploaded track does not fit into memory. The
oldest track log points were deleted to make space for the most recent data.
Transducer Disconnected, Sonar Turned Off —no transducer is attached,
the cable/transducer is bad, or the transducer cable was disconnected. If the
transducer cable is removed while the unit is on, reconnect and cycle power.
Transfer Complete —the unit has finished uploading or downloading information
to the connected device.
User Card Not Found —you attempted to transfer user data without a data card
in the data card slot.
Water Speed Sensor is not Working —the speed sensor is not detected. Check
the connections.
Water Temperature Alarm
—sonar has reported a temperature above, below,
inside, or outside the specified values.
Waypoint Already Exists: <Waypoint>
—you entered a waypoint name that
already exists in memory. Modify the waypoint name or delete the existing
waypoint.
Waypoint Memory Is Full, Can’t Create Waypoint
—you have used all 4,000
waypoints available. Delete unwanted waypoints to make space for new entries.