GPS 400 Pilot’s Guide and Reference
190-00140-60 Rev. E
SECTION 5
PROCEDURES
5-5
The steps required to set up and fly the approach
are detailed below (refer to Figure 5-9 for the following
steps):
1) Prior to departing KFDK, the destination (KLYH)
is selected using the
Direct-to
Key or by
creating a flight plan terminating at Lynchburg
Regional.
2) While enroute to KLYH, view the ATIS frequency
from the list on the NAV/COM Page (Section
2.6 and Figure 5-10). The ATIS frequency may
be used to tune an external COM transceiver.
Figure 5-10 NAV/COM Page
3) Press the
PROC
Key (Figure 5-11) and select
the ‘VOR 03’ approach using the steps outlined
in Section 5.1.
Figure 5-11 Procedures Page
4) From the Transitions Window (Figure 5-12),
select LYH VOR (the IAF). Also, select ‘Load?’
to load, but not activate, the approach.
Figure 5-12 Approach and Transitions Windows
5) Press the
PROC
Key, select ‘Activate Approach?’
and press the
ENT
Key to activate the
approach.
