GPS 400 Pilot’s Guide and Reference
190-00140-60 Rev. E
8-32
SECTION 8
AUX PAGES
3) Selecting ‘Config Fields’ configures the upper,
middle, and lower data fields to display user
selectable data information. Selecting ‘Traffic’
configures the upper and middle data fields to
display thumbnail traffic information (Figure
8-82). Press the
ENT
Key to accept the
Auxiliary Configuration selection.
Figure 8-82 Data Field Configuration Page w/Traffic
4) Press the small
right
knob to remove the cursor
and return to the Setup 2 Page.
NOTE: The ‘Traffic’ selection in the Auxiliary
Configuration Field is only available if the GPS
400 is configured for interface with a traffic
information device (see Section 10).
Restoring Factory Settings
When making changes to any Setup 2 Page option,
a ‘Restore Defaults?’ menu selection restores the original
factory settings (for the selected option).
Restoring a Setup 2 option to the original
factory settings:
1) Select the desired menu option from the
Setup 2 Page, using the steps described at the
beginning of this section.
2) Press the
MENU
Key to display the selected
page menu (Figure 8-83).
Figure 8-83 Data Field Configuration Page Menu
3) With ‘Restore Defaults?’ highlighted, press the
ENT
Key.
