GPS 400 Pilot’s Guide and Reference
190-00140-60 Rev. E
8-30
SECTION 8
AUX PAGES
Setup 2 Page: Nearest Airport Criteria
Setting the minimum runway length and
runway surface:
1) Select ‘Nearest Airport Criteria’ from the
Setup 2 Page, using the steps described at the
beginning of this section.
2) The flashing cursor highlights the runway
surface field (Figure 8-76). Turn the small
right
knob to select the desired surface. The
following options are available:
• Any surface
• Hard surfaces only
• Hard or Soft surfaces
• Water landings only
Figure 8-76 Surface Type Window
3) Press the
ENT
Key to accept the runway surface
selection.
4) The flashing cursor moves to the minimum
runway length field (Figure 8-77). To enter
a different minimum runway length, use the
small and large
right
knobs to enter the
desired length. Press the
ENT
Key when
finished.
Figure 8-77 Minimum Runway Length Field Selected
Setup 2 Page: Data Field Configuration
Configuring the Data Fields:
1) Select ‘Data Field Configuration’ from the
Setup 2 Page, using the steps described at the
beginning of this section. The flashing cursor
highlights the upper data field (Figure 8-78).
Turn the large
right
knob to highlight the data
field (upper, middle, or lower data field) to be
configured.
Figure 8-78 Upper Data Field Highlighted
2) Turn the small
right
knob to select the desired
data type (Figure 8-79). The available data
options are listed in Table 8-4.
