5 - PROCEDURES
98
190-00356-00 Rev G
Vectors-To-Final Approach
4. Select “Load?” (or “Activate?”, if already on
vectors-to-final).
To activate vectors-to-final from the procedures
page:
1. Select Billard Municipal (KTOP) as your desti-
nation, using the
direct-to
key or as the last
waypoint in a flight plan.
2. Press the
PROC
key and select the “VOR 22”
approach.
3. From the transitions window, select “LEBVY”
as the IAF. Also, select “Load?”.
4. When cleared, press the
PROC
key and select
“Activate Vector-To-Final?”.
Flying the Vectors Approach
With “vectors to final” selected, the CDI needle
will remain off center until you’re established on the
final approach course. With the approach activated,
the
map page
will display an extension of the final
approach course in magenta (remember, magenta is
used to depict the active leg of the flight plan) and
“VTF” will appear as part of the active leg on the
default NAV page
(as a reminder that the approach was
activated with vectors-to-final). In this example, we’ll
assume ATC vectors result in a rectangular course to
intercept final, as follows:
DO NOT USE FOR
NAVIGATION
1. When VTF is activated, the 400W-series unit
switches to approach mode and course guid-
ance is given along the final approach course.
CDI full-scale deflection is as shown in Appen-
dix C.
Summary of Contents for GNS 400W
