Garmin GNC 420, Pilot'S Manual & Reference

Page: 102 / 258

GNC 420(A) Pilot’s Guide and Reference
SECTION 6
PROCEDURES
6-18
Selecting ‘VECTORS’ from the Transitions
Window:
1) Select Billard Municipal (KTOP) as the
destination, using the
Direct-to
Key, or as the
last waypoint in a flight plan.
2) Press the PROC Key and select the ‘VOR 22’
approach using the steps outlined in Section
6.1.
3) From the Transitions Window, select ‘VECTORS’
(Figure 6-49).
Figure 6-49 Transitions Window
4) Select ‘Load?’ (or ‘Activate?’, if already cleared
for the approach).
Activating vectors-to-final from the
Procedures Page:
1) Select Billard Municipal (KTOP) as the
destination, using the
Direct-to
Key or as the
last waypoint in a flight plan.
2) Press the
PROC
Key and select the ‘VOR 22’
approach using the steps outlined in Section
6.1.
3) From the Transitions Window, select ‘D258G’
as the IAF (Figure 6-50). Also, select ‘Load?’.
Figure 6-50 Transitions Window
4) When cleared, press the PROC Key and select
‘Activate Vector-To-Final?’ (Figure 6-51).
Figure 6-51 Procedures Page
Flying the Vectors Approach
With ‘vectors to final’ selected, the CDI needle remains
off center until the aircraft is established on the final
approach course. With the approach activated, the Map
Page displays an extension of the final approach course in
magenta (magenta is used to depict the
active leg of the
flight plan) and ‘VTF’ appears as part of the active leg on
the Default NAV Page (as a reminder that the approach
was activated with vectors-to-final).
190-00140-20 Rev. K