Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO & CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
566
Appendix A
System Message
Comments
DIG GMA1 MANIFeSt
– Software mismatch,
communication halted.
The audio controller has incorrect software installed. The system should be serviced.
GMA1 SeRVICe
– GMA1
needs service. Return unit for
repair.
The audio controller self-test has detected a problem in the unit. Certain audio functions may still
be available, and the audio controller may still be usable. The system should be serviced when
possible.
GMc 720 Afcs controller sYsteM MessAGes
System Message
Comments
GMC CoNFIG
– GMC Config
error. Config service req’d.
Error in the configuration of the GMC 720.
GMC FAIL
– GMC is
inoperative.
A failure has been detected in the GMC 720. The GMC 720 is unavailable.
GMC MANIFeSt
– GMC
software mismatch.
Communication halted.
The GMC 720 has incorrect software installed. The system should be serviced.
GMC KeYStK
– GMC [key
name] key is stuck.
A key is stuck on the GMC 720 bezel. Attempt to free the stuck key by pressing it several
times. The system should be serviced if the problem persists.
MiscellAneous sYsteM MessAGes
System Message
Comments
FPL WPt LoCK
– Flight plan
waypoint is locked.
Upon power-up, The system detects that a stored flight plan waypoint is locked. This occurs
when an aviation database update eliminates an obsolete waypoint. The flight plan cannot
find the specified waypoint and flags this message. This can also occur with user waypoints
in flight plans that are deleted.
Remove the waypoint from the flight plan if it no longer exists in any database, or update the
waypoint name/identifier to reflect the new information.
FPL WPt MoVe
– Flight plan
waypoint moved.
The system has detected that a waypoint coordinate has changed due to a new navigation
database update. Verify that stored flight plans contain correct waypoint locations.
tIMeR eXPIRD
– Timer has
expired.
The system notifies the pilot the timer has expired.
DAtABASe CHANGe
–
Database changed. Verify user
modified procedures.
This occurs when a stored flight plan contains procedures that have been manually edited.
This alert is issued only after a navigation database update. Verify the user-modified
procedures in stored flight plans are correct and current.
DAtABASe CHANGe
–
Database changed. Verify
stored airways.
This occurs when a stored flight plan contains an airway that is no longer consistent with the
navigation database. This alert is issued only after a navigation database update. Verify use
of airways in stored flight plans and reload airways as needed.
FPL tRUNC
– Flight plan has
been truncated.
This occurs when a newly installed navigation database eliminates an obsolete approach or
arrival used by a stored flight plan. The obsolete procedure is removed from the flight plan.
Update flight plan with current arrival or approach.
This manual downloaded from http://www.manualowl.com