190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
463
AutomAtic Flight control SyStem
Sy
Stem
o
Ver
Vie
W
Flight
in
Strument
S
ei
S
Au
D
io
P
A
nel
&
cn
S
Flight
m
A
n
Agement
hAZA
rD
AV
oi
D
A
nce
AF
cS
ADD
ition
A
l
Fe
Ature
S
APP
en
D
ice
S
in
D
eX
ApproAch moDeS (FmS, vApp, loc)
note:
The selected navigation receiver must have a valid VOR or LOC signal or active FMS course for the
flight director to enter Approach Mode.
Approach Mode is activated when the
APR
Key is pressed. Approach Mode acquires and tracks the
selected navigation source (FMS, VOR, or LOC), depending on loaded approach. This mode uses the selected
navigation receiver deviation and desired course inputs to fly the approach. Pressing the
APR
Key when
the CDI is greater than one dot arms the selected approach mode (annunciated in white to the left of the
active lateral mode). If the CDI is less than one dot, the LOC is automatically captured when the
APR
Key
is pressed.
VOR Approach Mode (VAPP) provides greater sensitivity for signal tracking than VOR Navigation Mode .
Selecting VOR Approach Mode:
1)
Ensure a valid VOR frequency is tuned.
2)
Ensure that VOR is the selected navigation source (use the
Active Nav
Softkey to cycle through navigation
sources if necessary).
3)
Press the
APR
Key.
When FMS Approach Mode is armed, Glidepath Mode is also armed.
Selecting FMS Approach Mode:
1)
Ensure a FMS approach is loaded into the active flight plan. The active waypoint must be part of the flight plan
(cannot be a direct-to a waypoint not in the flight plan).
2)
Ensure that FMS is the selected navigation source (use the
Active Nav
Softkey to cycle through navigation
sources if necessary).
3)
Press the
APR
Key.
Figure 7-24 Navigation/Approach Mode Armed
LOC Approach Mode allows the autopilot to fly a LOC/ILS approach with a glideslope. When LOC Approach
Mode is armed, Glideslope Mode is also armed automatically. LOC captures are inhibited if the difference
between aircraft heading and localizer course exceeds 105°.
Selecting LOC Approach Mode:
1)
Ensure a valid localizer frequency is tuned.
2)
Ensure that LOC is the selected navigation source (use the
Active Nav
Softkey to cycle through navigation
sources if necessary).
3)
Press the
APR
Key.
Or
:
This manual downloaded from http://www.manualowl.com
