Garmin G1000 Series, Pilot'S Manual, Page: 69 / 338

Garmin G1000 Pilot’s Guide for the Diamond DA40
190-00592-00 Rev. A 2-41
PRIMARY FLIGHT DISPLAY
3. Turn the FMS knob to select the desired arrival,
then press the
ENT
key. A window appears
listing the available transitions for the arrival.
Figure 2-68 Arrival Transition
4. Turn the FMS knob to select the desired transi-
tion, then press the
ENT
key.
5. A window may appear listing runways for the
arrival. Turn the FMS knob to select the desired
runway, then press the ENT key.
NOTE: The runway window is not displayed for
every arrival. ‘ALL’ may appear in the runway
field, indicating that the arrival procedure applies
to all runways. For airports with parallel runways,
‘B’ may appear at the end of the runway designa-
tion to indicate that the arrival procedure applies
to both runways.
Figure 2-69 Arrival Runway
6. With ‘LOAD?’ highlighted, press the ENT key.
NOTE: When adding an arrival to an active flight
plan, the pilot may need to remove a duplicate
destination waypoint from the flight plan list.
Figure 2-70 Select Arrival Window
Select Departure
Select Departure allows the pilot to choose a published
standard instrument departure (SID) for the departure
airport, or replace the current departure with a new selec-
tion. When using a direct-to, the G1000 uses the nearest
airport as a reference when displaying available depar-
tures.
To select a departure for the departure
airport:
1. From an active flight plan, press the PROC key
to display the Procedures options window.
2. Turn the
large FMS
knob to highlight ‘Select
Departure’, then press the ENT key. A window
appears listing the available departures for the
departure airport.
3. Turn the FMS knob to select the desired depar-
ture, then press the
ENT
key.
4. A window may appear listing runways for the
departure. Turn the FMS knob to select the
desired runway, then press the
ENT
key. The
transition window is now displayed.