Garmin G1000 Series, Pilot'S Manual, Page: 60 / 338

Garmin G1000 Pilot’s Guide for the Diamond DA40
190-00592-00 Rev. A 2-32
PRIMARY FLIGHT DISPLAY
Direct-to Window
The Direct-to Window is enabled/disabled by pressing
the
Direct-to
key.
Figure 2- Direct-to Window
The currently selected waypoint displays the following
information:
• Identifier
• Waypoint symbol
• Waypoint location
• Facility name
• Flight plan waypoint list
• Nearest waypoint List
• Bearing to waypoint
• Distance from waypoint
• Latitude/longitude
• Course to selected waypoint
Direct-to Navigation
Selection of a waypoint for Direct-to navigation may be
done in several ways:
• By specifying the identifier, waypoint location, or
facility name
• From a list of waypoints in the active flight plan
• From a list of the 25 nearest airports
NOTE: When entering an all-letter/alphabetical
airport identifier (only in the USA), the pilot must
precede it with the letter “K” (e.g., KMCI). If the
airport identifier is alpha-numeric, simply enter
the three-digit identifier (e.g., 51K). The full ICAO
identifier must be entered for all waypoints.
To select a Direct-to by identifier:
1. Press the Direct-to key, then turn the FMS knobs
to select the desired waypoint identifier. Press
the ENT key to confirm the selection.
2. Press the ENT key again to activate the direct-to.
To select a Direct-to by city or facility name:
1. Press the Direct-to key, then turn the large FMS
knob to highlight the city (line to the right of
the identifier), or the facility (line directly below
the identifier) field.
2. Turn the FMS knobs to enter the city (line to
the right of the identifier field), or the facility
(line directly below the identifier field). Once
the desired city or facility name is displayed,
press the ENT key to confirm the selection.
3. Press the ENT key again to activate the direct-to.
To select a Direct-to from a list of
waypoints in an active flight plan:
1. Press the
Direct-to
key, then turn the
large FMS
knob to highlight the FPL field.
2. Turn the small FMS knob to display a selection
window showing all waypoints in the active
flight plan.
3. Turn the FMS knob to scroll through the list and
highlight the desired waypoint, then press the
ENT key.
4. Press the
ENT
key again to activate the direct-to.