Garmin G1000 Series, Pilot'S Manual

Page: 53 / 338

Garmin G1000 Pilot’s Guide for the Diamond DA40
190-00592-00 Rev. A 2-25
PRIMARY FLIGHT DISPLAY
The following Inset Map operations can be performed
independently of the MFD:
• Change zoom range
• Change declutter level
• Enable/disable traffic data
• Enable/disable topographic data
• Enable/disable terrain data
• Enable/disable weather information (optional)
• Pan Map
Figure 2-42 Inset Map
1
9
8
2
3
4
5
7
6
NAV Compass Range
3
4
9
7
2
5
6
8
1
Wind Vector
Map Range
NAV Compass
Traffic Icon and Scale
Terrain Icon
Active Navigation Route
Track Vector
Map Orientation
To change the zoom range:
Turn the joystick clockwise to increase or
counterclockwise to decrease the range. Zoom
ranges from 500 feet to 2,000 nautical miles.
To change the declutter level:
1. Press the INSET softkey.
2. Press the DCLTR softkey to remove background
map details until the desired amount of detail is
depicted. The declutter level appears above the
softkey (i.e. DCLTR-1). Refer to the Multi Func-
tion Display Pilot’s Guide for more detail.
To enable/disable traffic data:
1. Press the
INSET
softkey.
2. Press the
TRAFFIC
softkey to display Traffic
Information Service (TIS) traffic. Traffic symbol-
ogy appears next to the aircraft icon and at the
bottom right corner of the map.
3. Press the TRAFFIC softkey again to remove data
from the map.
NOTE: TIS displays traffic within seven nautical
miles from 3,000 feet below to 3,500 feet above
the requesting aircraft, and includes location,
direction, altitude, and climb/descent informa-
tion.
NOTE: If a second TA appears or if the number
of TAs displayed decreases then increases, new
audio and visual alerts are generated.
NOTE: Refer to the Appendix for more details
about Traffic Information Service (TIS).