Garmin G1000 Series, Pilot'S Manual

Page: 47 / 338

Garmin G1000 Pilot’s Guide for the Diamond DA40
190-00592-00 Rev. A 2-19
PRIMARY FLIGHT DISPLAY
DME Radio (optional)
The DME radio is a Honeywell KN63 remote mounted,
200-channel, 100-watt, all-solid-state digital DME which
provides distance information to the G1000.
Press the PFD softkey followed by the DME softkey
to display the DME Information Window. The DME In-
formation Window is displayed above the BRG1 Informa-
tion Window and displays the DME label, tuning mode
(NAV1, NAV2, or HOLD), frequency, and distance. When
a signal is invalid, the distance is replaced by “–.– – NM.”
The pilot may select from three DME tuning modes:
• NAV1 – Tunes the DME frequency from the selected
NAV1 frequency
• NAV2 – Tunes the DME frequency from the selected
NAV2 frequency
• HOLD – When transitioning from NAV1 or NAV2
mode to Hold mode, the DME frequency remains
set to the last selected NAV frequency
NOTE: When navigating in GPS mode, the dis-
tance displayed is the GPS-derived great-circle
distance, not the actual DME distance.
Figure 2-30 DME Information Window
ADF Radio (optional)
The ADF radio is a Becker RA3502 (1) remote mount-
ed ADF radio receiver that operates in the frequency range
190.0 to 1799.5 kHz in 0.5 kHz increments.
The ADF bearing source is selected by pressing the
PFD softkey, then by pressing the BRG1 or BRG2 softkey
(as desired) until ADF is displayed.
The audio volume for the ADF is displayed and ad-
justed from the Radio Tuning window. The ADF radio has
three tuning modes as described below:
•
ANT
(antenna) mode – Parks the ADF pointer at
the three-o’clock position on the HSI
The Morse code can also be identified.
• BFO (beat frequency oscillator) mode – Provides
an audible tone detected through the receiver when
a frequency is tuned in
No Morse code is heard.
• ADF mode – The ADF bearing pointer should
point to the station
The Morse code can also be identified.
Figure 2-31 ADF Selected in BRG2 Information Window