G1000 Supplemental Maintenance Manual
Page 9-1
Textron Nav III Series
Revision 3
190-02128-04
9. G1000 System Return to Service Procedure
If a G1000 LRU was replaced, verify the correct LRU software part numbers and versions
against the numbers listed on the General Arrangement drawing listed in Table 1-1.
Perform the following subsection tests to confirm the G1000 system is operating correctly.
9.1 Display Test
Apply aircraft power. On the MFD power-up screen in the upper right corner, find the
‘Cessna XXX System XXXX.XX’ number, where XXX is the airframe type and XXXX-XX
is the number of the G1000 System Software Loader Image version number that was
used to install the software to the system. (182T image shown for reference, others are
similar)
Figure 9-1, MFD Power Up Page
Verify that the System Software Version is the same as listed in Table 1 of the 005-
00620-22 General Arrangement Drawing.
Press the MFD
ENT
key to acknowledge the
‘DEFAULT PROFILE’ Crew Profile option
on the MFD (NOTE: The rightmost softkey may also be used).
Summary of Contents for G1000 NXi
Page 61: ......
