Garmin Cessna Caravan G1000, Reference Manual

Page: 18 / 106

Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang 190-00600-02 Rev. A
2
Flight instruments
Flight
Instruments
EICAS
Nav/Com/
XPDR/Audio
AFCS
GPS Nav
Flight
Planning
Pr
ocedur
es
Hazar
d
Avoidance
Additional
Featur
es
Abnormal Oper
ation
Annun/
Alerts
Appendix
Index
ChAnge nAvigAtion sourCes
1)
Select the
CDI
Softkey to change from GPS to VOR1 or LOC1. This places
the light blue tuning box over the NAV1 standby frequency in the upper left
corner of the PFD.
2)
Select the
CDI
Softkey again to change from VOR1 or LOC1 to VOR2
or LOC2. This places the light blue tuning box over the NAV2 standby
frequency.
3) Select the CDI Softkey a third time to return to GPS.
enAble/disAble obs mode While nAvigAting With gps
1) Select the OBS Softkey to select OBS Mode.
2) Turn a CRS Knob to select the desired course to/from the waypoint. Press
the CRS Knob to synchronize the Selected Course with the bearing to the
next waypoint.
3) Select the OBS Softkey again to disable OBS Mode.
generiC timer
1)
Select the TMR/REF Softkey, then turn the large FMS Knob to select the
time field (hh/mm/ss). Turn the
FMS
Knobs to set the desired time, then
press the
ENT
Key. The UP/DOWN field is now highlighted.
2)
Turn the small
FMS
Knob to display the UP/DOWN window. Turn the
FMS
Knob to select ‘UP’ or ‘DOWN’, then press the
ENT
Key. ‘START?’ is now
highlighted.
3)
Press the
ENT
Key to START, STOP, or RESET the timer (if the timer is
counting DOWN, it will start counting UP after reaching zero). Press the
CLR Key or the TMR/REF Softkey to remove the window.
ConFigure vspeed bugs individuAlly
1)
Select the
TMR/REF
Softkey.
2)
Turn the large
FMS
Knob to highlight the desired Vspeed.
3)
Use the small
FMS
Knob to change the Vspeed in 1-kt increments (when a
speed has been changed from a default value, an asterisk appears next to
the speed).