34
Navigator III Owner’s Manual
A
PPENDIX
A
PPENDIX
Removing Your Navigator III from the
Motorcycle Mount
1. Use the security screwdriver to loosen the screw on the top
of the cradle lock.
2. Lift the cradle lock up until it clicks.
3. Pull the BMW Motorrad Navigator III unit out of the mount.
4. Slide the power connector to the left to disconnect the
power cable.
Connecting to Your Computer
NOTE:
Do not connect the USB cable to your computer until
you have loaded the USB drivers using the enclosed DVD-
ROM.
To update your software, load additional maps, or load Custom
POIs, connect your Navigator III to your computer using the USB
cable provided.
Step 1: Load the USB Drivers
Before connecting the USB cable to your computer, place the
enclosed DVD-ROM into your computer’s DVD-ROM drive.
If the DVD-ROM does not start automatically, click
Start
and
then
Run…
. Type the letter of your DVD-ROM drive followed
by “setup” (example: “D:\setup”). Then press
Enter
. Follow the
on-screen instructions.
Step 2: Connect AC Power
Connect the enclosed AC power cable to the power connector
on the back of the Navigator III Connect the end to an available
electrical outlet.
