Garmin Apollo CNX80, Pilot'S Manual

Page: 44 / 162

36
Basic Operation
4. Press
Menu/Enter
to accept the new destination waypoint. Press
Menu/Enter
again to activate it.
By changing the destination, the PROC or FPL Edit modes can be used to load and execute Arrival and/
or Approach procedures to the new destination. This feature replaces the active flight plan with a new
one-leg flight plan direct from your present position to the selected destination.
NOTE : The BACK key returns you to the original Direct-To page.
Course-To (CrsTo)
Course-To operation allows you to select an inbound intercept course for the selected waypoint. The default
course to the operation is the course from the present position to the selected waypoint. Upon reaching the
selected waypoint, if the waypoint is in the active flight plan, the flightplan will sequence to the next waypoint
in the flightplan normally.
1. Press
Direct-To
. Use the
Large
knob to highlight a waypoint in the active flight plan or press
DB
to
select a new waypoint with the
Large
and
Small
knobs.
2. Press CrsTo . A map is displayed showing the selected course.
3. Change the course bearing, if desired. Turn the
Large
knob to change the value in 10° increments. Turn
the
Small
knob to change the value in 1° increments.
4. Press Menu/Enter .
Course From (CrsFr)
The Course From operation allows you to navigate from a waypoint on a pre-defined course. The default
course for the Course From operation will depend on whether your aircraft is heading toward the selected
waypoint or away from it. If your aircraft is heading toward the selected waypoint, the default course will be
the bearing from the present position to the selected waypoint. If you are heading away from the waypoint,
the default course will be the bearing from the waypoint to your present position. The length of the magenta
course line will always be 100 nm.
When the Course From operation is executed, the To-From indicator will indicate FROM and the flightplan
will go into suspend mode (SUSP); it will not automatically sequence the flightplan waypoints. To rejoin your
flight plan, highlight a waypoint in your active flight plan and either press the Direct or FlyLeg menu item
keys.
Setting a Direct-To Course To
Setting a Direct-To Course From
Direct-To