Fitting the Collar on Your Dog
CAUTION
Do not spray the device or collar with
harsh chemicals including but not limited
to flea or tick spray. Always ensure that
any flea or tick spray that is applied to the
dog is completely dry before placing the
collar on the dog. Small amounts of harsh
chemicals can damage the plastic
components and collar laminate.
Before you can put the collar on the dog,
you must pair the handheld device and
collar (page 3), and acquire satellite
signals (page 3).
1
Position the collar with the whip
antenna pointing up, the GPS antenna
facing up, and the LEDs facing
forward.
2
Place the collar around the middle of
the dog's neck.
3
Tighten the strap so it is snug around
the dog's neck.
NOTE:
The collar should fit tightly and
should not be able to rotate or slide on
the dog's neck. The dog must be able
to swallow food and water normally.
You should observe your dog's
behavior to verify the collar is not too
tight.
4
If the strap is too long, cut off the
excess, leaving at least 7.62 cm (3 in.)
to spare.
Dog Tracking
The handheld device allows you to track
your dog, using the tracking compass or
map. The map displays your location and
your dog's location and tracks. The
compass pointer indicates the direction of
the dog's current location.
Communication with the Collar
You should keep an unobstructed line of
sight between your handheld device and
the dog collar device to produce the best
communication signal. To achieve the best
line-of-sight conditions, you should move
4
Quick Start Manual
