INSTRUCTIONS FOR PROGRAMMING “ANGUS 3 1 - CLAM”
EPROM chip – 4516691
– Version 7.30 or 7.31 – Multi-Stage Chip
Product Name: “Angus 3 1 – CLAM”
Gap Setting - .534
Remove Time – 165 sec
Top Temp – 425 degrees F
˚
Bottom Temp – 350 degrees F
˚
MAXIMUM RUN SIZE: 4
1. PRESS
and
HOLD
the
"PROG"
button for
five, (5), seconds.
(Display will flash GC450 and the program
version number).
2. PRESS
the
"PROG"
button
twice
to display
"SYSTEM SETUP."
3. PRESS
and
HOLD
the
"UP ARROW"
button (
) for
ten (10) seconds, “GAP CALIBRATION"
will be
displayed.
4. PRESS
the
"PROG"
button
twice
to display “
MENU ITEMS."
5. PRESS
the
"MENU"
button to display “OPTIONAL MENU (1)(2)(3) Clam”.
6. PRESS
the “
UP ARROW
” button (
) to change “
YES
”.
7. PRESS
the
"FUNCTION"
button to obtain
"REMOVE IN XXX"
8.
USING the “UP ARROW” button
(
)
and the “RIGHT ARROW” button
(
change the remove time to
“
165
”
9. PRESS
the “
FUNCTION
” button to display “
ALARM
”.
10. PRESS
the “
UP ARROW
” button (
) to change the setting (
AUTO/MANUAL
).
11. PRESS
the “
FUNCTION
” button to obtain “
GAP
SETTING
”.
12. USING the “UP ARROW” button
(
)
and the “RIGHT ARROW” button
(
), change the Gap Setting to
“
534
”
a. FUNCTION THROUGH STAGE #1,2,3 - TIMES & GAPS SHOULD BE “000”
13. PRESS
the “
FUNCTION
” button to display “
TOP TEMP
”.
14. USING the “UP ARROW” button
(
)
and the “RIGHT ARROW” button
(
), change the Top Temperature
set point to “
425
”
15. PRESS
the “
FUNCTION
” button to display “
BOTTOM TEMP XXX
”. Bottom Temp. Default = OFF.
16. USING the “UP ARROW” button
(
)
and the “RIGHT ARROW” button
(
), change the Bottom
Temperature set point to “
350
”
17. PRESS
the “
FUNCTION
” button to display “
TOO COOL DELAY: NO”
(Use (
) to change to
NO
if not
flashing NO)
18. PRESS
the “
FUNCTION
” button to obtain display the first available “
OPTION MENU ? – CLAM YES”.
To enter in “ANGUS 3 1 – CLAM”:
a. PRESS
the “
UP ARROW
” button (
) to change the value of the flashing digit.
b. PRESS
the “
RIGHT ARROW
” button (
) to advance the cursor to the right for changing its value.
(Alpha-numeric capabilities).
c. PRESS
the
"PROG"
button to display
"MENU ITEMS".
d. PRESS
the
"RIGHT ARROW"
button (
) to return to the normal
OPERATING MODE.
NOTE: after programming the following menu item in the controller, you must check to ensure that the grill will
function properly in this menu mode. Start a cook cycle (you may do this with or without product) to ensure that the
upper platen functions properly. If in the event that the controller displays “Motor Overcurrent”, contact your local
service center.
