![background image](http://html1.mh-extra.com/html/gardner-denver/welch-lvs-105-t-10-ef/welch-lvs-105-t-10-ef_operation-manual_3569511049.webp)
Operation
Operation Manual LVS 105 T
– 10 ef
+
49
6.4.7
Calibrate
The calibration can be done here just like on the end device. A two-point calibration with
comparison measurement device can be performed.
Procedure
1. Evacuate the system for the lower point using the
search
lower point (Pmin) (1).
2. Take over the value with
Ok
(2) when the pressure stops dropping.
3. Ventilate the system for the upper point using the
search
upper point (Pmax) (3).
4. Take over the value with
Ok
(4) when the pressure stops rising.
5. Take over the settings with
save
(5). The calculated calibration coefficients are displayed.
Calibration with atmospheric pressure:
Calibration with low pressure (ultimate
pressure):
The diaphragm pump is switched off
The diaphragm pump is switched on
The ventilation valve is open
The ventilation valve is closing
The vacuum control valve is closed
The vacuum control valve is opening
Sensor exposed to the ambient pressure
Sensor exposed to the ultimate pressure