![background image](http://html1.mh-extra.com/html/gardner-denver/welch-lvs-105-t-10-ef/welch-lvs-105-t-10-ef_operation-manual_3569511043.webp)
Operation
Operation Manual LVS 105 T
– 10 ef
+
43
6.4.2
Connection settings
The vacuum controller can be addressed via RS 232 or LAN. Using the menu bar (see sec-
tion
screen), it is possible to establish the connection under [Communication set-
tings].
(1) The port rocker switch can be set either to RS 232 oder LAN.
(2) For ComPort, all ComPorts found on the PC are listed. Select the port used.
(3) The
Search
button activates the search for the vacuum controllers in the
LAN network
,
in the LAN mode:
o
The list of vacuum controllers connected to the network is updated.
o
You can select a vacuum controller unit via the
IP/Name
list.
o
The selected vacuum controller is recognized on a pre-defined UDP port via broadcast
key.
(4) The
Connect
button is used to establish the connection.
NOTE
Only one connection is permitted per vacuum controller!
DEVICE NAME
►
The name is the 6-digit serial number of the device (see type label) and
is displayed after the IP address as SNXXXXXX.
NOTE
►
If the device is locked, either the user password or the admin password
is requested in order to unlock the end device and thus to transfer the
commands to the end device via the PC software.
►
The exception is the first press of the STOP button, which can be
pressed without a password, also on the end device, for safety reasons
in order to switch off the function of the end device.